Peugeot 308 Key Fob Replacement
Peugeot's 308 is a bit old but it's still striking. It might not be the most luxurious car in its class It's a Ford Focus or Volkswagen Golf will protect you from surface imperfections - however, it's a comfortable and comfortable drive.
We are often asked at Coded Car Keys to replace peugeot key fobs. peugeot 308 key following tips can aid whether the issue is persistent or intermittent.
Water Damage
If you accidentally drop your key fob into a puddle, or if it is wet while kayaking, canoeing, rafting, or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry bag every time you go outdoors or do activities that could expose it to excessive water.
You'll also want to ensure that the fob is dry prior to opening it and using it again. If you notice any odors coming from the fob, such as an industrial-type liquid smell or the scent of windshield washer fluid, this is another sign that it's been submerged in water.
A circuit board that's wet can cause the battery to discharge its charge, or even explode. If you're able to pull your 308 key fob out of the water body it got stuck in it, flip the button side down and shake out as much water as possible before opening the case. Remove the battery, then clean the circuit board with a cotton swab, which has been dipped into 90-percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system might not function include a dead coin cell battery or receiver module issue signal interference or a damaged chip. If none of these are the cause, you can try resetting the system by removing the battery with 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start systems that lets drivers start their vehicle from a distance, allowing them to warm up or cool down the vehicle prior to entering. This feature is very useful, especially in the cold winter months. The remote start system may be stopped for a variety of reasons, such as the dead battery in the coin-battery.
The coin-shaped battery located inside the key fob could last between two and four months, depending on how often it's used, the location it was purchased, and the way it is utilized. Its use-by date is typically printed on the package or written in the manual.
If the key fob is no longer working after exposure to pure tapwater, you need to remove the battery and clean the electronic chip using the aid of a towel soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing. If exposed to soapy or salty water, the chip might be fried and you will need to replace the key fob in total.
If you're not sure whether the battery is in good condition you can check the voltage using a multimeter connected to both the plus and minus terminals. If the voltage is lower than 12-13 volts, you need to replace the battery. Alternatively, you can try to reset the on-board computer by disconnecting the 12 volt battery for a few minutes and then reconnecting it in reverse order (positive cable first followed by negative). The engine should then start after this.
Faulty Receiver Module
If you don't see "Key Detected", it could be that your receiver module is defective. It's the component that sends out a signal when your key fob goes off. It also acts as an alarm that stops the car from starting without the correct key.
This can be due to several factors, including water damage or simply aging. If your Peugeot 308 key fob has been exposed dirty tap water, like, the electronic chip inside may be damaged. In this instance you'll need to remove the device apart and clean it thoroughly using isopropyl alcohol, or electronic cleaner. When the battery is clean then you can try again.
If the issue persists, it is recommended to visit a local Peugeot expert or locksmith. They can employ a diagnostic tool in order to pinpoint the issue and fix it.
The loss of your Peugeot keys to your car is an incredibly stressful experience. However, a professional auto locksmith can fix the issue in only a few minutes. They can program your car and cut a new, functioning key for you. Click here to find a locksmith near you.
A malfunctioning electronic chip
The electronic chip inside your Peugeot 308 key fob is a very crucial component of the remote control system. If it becomes damaged, your car may not start or receive a message saying "anti-theft active". In this situation, the only solution is to replace the key. Professional auto locksmiths are able to offer the fastest possible time.
The chip inside your Peugeot 308 key fob can become faulty due to water damage, sweat dirt, or any other cause. If your Peugeot key fob has been exposed soapy or dirty water, it must be cleaned right away. You can make use of a paper towel and isopropyl alcohol to wipe the electronic component. Then, you need to allow the battery to completely dry.
Radio interference can cause a key fob's functionality to cease. This is usually caused by other devices operate on the same frequencies as your Peugeot keyfob. It can also be caused by weather conditions or objects around the vehicle. If you experience this problem it is advised to visit the Peugeot dealership.
The Peugeot key fob 207/308 is extremely delicate and requires special attention. You should not drop it or throw it around. If you lose it, try to locate it as quickly as you can. You can reset the onboard computer by disconnecting the battery for a couple of minutes. Make sure you disconnect the negative first, and then the positive.